Wearable Technologies - First Try Out
* The hat (before embedding the LED).
* Metal wire.
* Using needle and metal wire to sew (the metal wire works as the thread).
*Sewing the metal wire on the hat.
* Tying the wire.
* Wire sewn on the hat.
* Another stripe of wire is sewn at the back of the hat.
* Front look of the hat.
* Wire sewn.
* Using bubble wrap to create an additional layer, so the two wires will not touch each other.
* Sewing the bubble wrap on the hat.
* Bubble wrap sewn.
* LED, resistor 100 Ω, and 1.5 volts batteries x 2.
* OFF - ON.
* Connecting the LED and the hat.
* After the joining.
* Wires around the hat.
* Hat after the joining.
* Soft button.
* OFF - ON.
No comments:
Post a Comment