- Candle and Wii-mote 's holder -
*Idea : Wii-mote could rotate but could not move up/ down, candle could move up/ down
*Idea #1 : The up/ down movements of the candle are moved using the GEAR system
EXPERIMENT FAILED
*The gears did not work very smoothly
*A limit in how tall the candle can move up to
*Idea #2 : The up/ down movements of the candle are moved using the SCREW system
*It works out pretty good, except the lock for the screw
*The candle could move up
*Needs to lock the below part of the screw to make the candle moves down
*The distance of movement depends on the length of the screw
*Picture description : Sawing a piece of Balsa wood to make a table for the candle
*Accident does happen.
*The side is not cut properly
*Using a wood glue to stick the table to its legs
*Screw in the middle to move the small piece wood up and down
*The small piece wood will hold the candle and it can be move up and down
*The big piece wood will act as the base
*Hammering the screw in the wood and screw it using a screwdriver
*The small piece wood with a screw attached
*Waiting for the glue to dry up
*A 60.6 cm x 30.2 cm wood was being cut into 40 cm x 30.2 cm wood
*This after cut wood will act as the wall to hold the wii-mote
*Thickness of the wood is 1.2 cm, which made it hard to cut
*Hammering a hole to put the screw, which will hold the speaker mount, used to hold the wii-mote
EXPERIMENT FAILED
*Wood is too thick to poke a hole, aside from using a drill
No comments:
Post a Comment